|
![]() ![]() |
型號說明 model meanings
主要技術指標 main techniqueindessign
1. 環境溫度:-25℃ ~+50℃,濕度≤ 85%,海拔2000 米以下;
2. 額定電壓:120VAC,230VAC,400VAC,450VAC,525VAC,690VAC,750VAC,1050VAC;
3. 額定容量:1~80Kvar
4. 容量允差:-5~+10%
5. 損耗角正切值:在工頻額定電壓下,20℃時tanδ ≤ 0.1%;
6. 耐電壓:極間2.15 倍額定電壓5 秒鐘,極殼間3KVAC 可10 秒鐘;
7. 絕緣性: 極殼間500VDC,1 分鐘.R ≥ 1000MΩ;
8. 最高允許過電壓:1.10 倍額定電壓;
9. 最高允許過電流:1.30 倍額定電流;
10. 自放電特性:電容器斷電后3 分鐘,剩余電壓從 2 Un 降至75v 或更低;
11. 符合標準:GB/T12747.1-2004,IEC60831-1996。
1.Ambiebt temperature:-25℃ ~+50℃ .Humidity ≤ 85% ,Atitudenot higher than;
2.Rated voltage:120VAC,230VAC,400VAC,450VAC,525VAC,690VAC,
750VAC,1050VAC;
3.Rated capacitw:1~80KVar;
4.Capacitance tolerance:-5~+10% ;
5.Tangent of the loss angle:With the power frequency rated voltage 20℃ Hour tanδ ≤ 0.1% ;
6.Withstand voltage:Between terminals 2.15 times ratde voltage for
5 secomdes,between terminal and contain and container 3KVac for 10 secomds;
7.Insulation level:Betwee terminals and container 500DC,l minute. R ≥ 1000MΩ;
8.Maximum allowable over-voltage: 1.10 times rated voltage;
9.Max permissible over-current:1.30 times rated current;
10.Self sustained discharge ability:Give Un DC voltage to capacitor, the residual voltage to 75v or lower within 3minutes after power off;
11.Applicable standard:GB/T12747.1-2004.IEC6083l-1996.
主要特點 main features
1. 體積小,重量輕
由于采用金屬化聚丙烯膜新材料作為介質,體積、重量僅為老產品的1/4 和1/5;
2. 損耗低
實際值低于0.1%,所以電容器自身的能耗低、發熱少、溫升低、工作壽命長、節能效果佳;
3. 優良的自愈性能
過電壓所造成介質局部擊穿能迅速自愈,恢復正常工作,使可靠性大為提高;
4. 安全性
內裝自放電電阻和保險裝置,使用安全可靠;
5. 不漏油
本產品采用微晶蠟作為浸漬劑,常溫呈固態,熔點高于70℃,在使用過程中不漏油,避免環境污染。
1.Compacted and light
Its volume and weight are only 1/4 and 1/5 of the old product because of the using of new dielectric-metallized polypropylene film.
2.Low loss
The real figure is lower than 0.1%,so the capacitor itselfis extremely low the heat it gives out is little and the rise oftemperature is low.So its service.life is very long and it can save energy at the same time.
3.Excel lent self-healing ability
Damage of part of the dielectric caused by over-voltage can be self-healed quickly and return to normal state.So the reliability is much higher.
4.Safety
In wardly equipped self-discharge rseistor and safly equioment.
5.Nooil leakage
The capacitor uses advanced.Semi-solid impregnant whose drip melting point is above 70℃ ,There will be no loss of oil during the course of using it.And thus the surrounding is out from being polluted.The capacitor itself doesn’t have to run the risk of invalidation caused by oil leakage.
此信息由浙江金力電氣有限公司在環球電氣網發布,獲取優惠采購價格,聯系時請說明來自環球電氣網!
免責聲明:以上所展示的信息由會員自行提供,內容的真實性、準確性和合法性由發布會員負責。環球電氣網對此不承擔任何責任。
友情提醒:為規避購買風險,建議您在購買相關產品前務必確認供應商資質及產品質量!